The EASZ-1 TF1 Watercut Monitor addresses a problem faced by piping engineers who wish to comply with standards pertaining to inlet and outlet connections e.g. the ANSI or DIN pressure ratings etc. Since sensors reside inside the process it is important not to forget that the leak paths from the sensor to the environment are also subject to the same leakage parameters as the flanged process connections.

Therefore EESIFLO International also design and manufacture the EASZ-1 TF1 so that ALL connections to the process and from the process are inline with MANDATORY piping specifications.

EESIFLO International produces instrinsically safe Zone 0 and Zone 1 watercut monitors designed to provide the highest possible sensitivity, resolution, and accuracy for water content determination in crude oil, other hydrocarbons, or other low dielectric liquids from a max of 100% to levels below 1000 parts per million (ppm). In oil and natural gas (condensate) production, watercut measurements are significantly improved with the EASZ-1 technology.

Enhanced digital signal processing and full product temperature compensation are two of the technological advancements utilized by this device. Full bore meter sizes from 1” through 42 ” and a. 4- 20 outputs are available for remote readout. Water cut, process temperature and dielectric values are measured accurately and can be reported back to a control centre.

Product Temperature Compensation

The base dielectric constant (Dk) of oils can change with changes in temperature. This can cause traditional monitors to change without a variance in water content. For example; for a 10°F change, a typical curde oil may show a reading shift of as much as 0.1%, which normally would be considered as water. The EASZ-1 measures product temperature and calculates a corrected cut reading, providing a true watercut at any temperature

EESIFLO International is an original design , engineering company with unique products manufactured in house and installed in major upstream or downstream oil companies around the world , in oil distribution, oil transportation and oil quality management in general industries including marine and chemical engineering. We manufacture standard products for the general industry and also specialized products for oil and gas companies who require vendors to meet strict quality procedures for high pressure equipment or equipment that will be used in hazardous areas.

A brief introduction to the company can be seen in this video..