Flow meters- Eesiflo Ultrasonic Flow Meters

This page is printable and fits in 1 A4 paper.

Relay 1

The relays can be used either for an external counter, high alarm or a low alarm. The difference is that a high alarm has its reset below the setpoint, and a low alarm has its reset above the setpoint.
DEFAULT Off

Relay 2

As above.
DEFAULT Off

Counter 1

The external counter or sampler can be set here. Select the amount of counts before the sampler will be activated.
DEFAULT 1000

Relay 1 High or Low depending upon selection

This is the setting for the High or the Low alarm depending on which is selected.
DEFAULT 0.00mm

Relay 1 Reset

This is where you can enter the reset. Please note that if it is a high alarm then the reset must be below and if it is a low alarm then the reset must be above the setting.
DEFAULT 0.00mm

Relay 2 High or Low depending upon selection

As above.
DEFAULT 0.00mm

Relay 2 Reset

As above.
DEFAULT 0.00mm

Totaliser Reset

The totaliser can be reset here.
DEFAULT No

Zero Offset

Should there be a small offset at the Zero this prompt can be used to offset it.
DEFAULT No

Offset

Up to a maximum of 50 mm minus and positive.
DEFAULT 0mm

Use Temperature Compensation

Select Yes only if a EESIFLO10C is used or a Temperature Transducer is connected.
DEFAULT No

Set New Password

This prompt will allow you to change the default factory password.
DEFAULT No

Factory Reset

This prompt will reset all values entered back to factory settings including the password. Please write down all settings before using this function.
DEFAULT No