The EESIFLO EASZ-3000 is a mains powered non -invasive microprocessor based meter for measuring the flow rate and total volume of liquids flowing through process and effluent pipelines. It is suitable for a wide range of liquids, including aerated water, liquids containing suspended solids, slurries and sludges. The EESIFLO EASZ-3000 requires fluids with a minimum concentration of 100 ppm of solids or bubbles having minimum size of 100 microns and works on most pipes 1 inch and above.

The flowmeter utilises the non-intrusive Doppler principle to measure the mean velocity and is particularly useful as a fixed flow indicator or as a working tool to establish flow conditions in field or plant installations. Units of measurement available are m/s, ls, lm, lh, m3/sec, m3/m, m3/hr, ft3/h, ft3/s, usgps, usgpm, usgph, usmgd. The unit has built in logic to cut off measurement of flow readings on applications which are not suited for Doppler measurement. Each unit is factory calibrated and ready to install and measure flow rates within seconds.

Slurries Dredging Pulps Primary sludge Digested sludge Thickened sludge Waste activated sludge Return activated sludge		Microprocessor controlled Programmable Easy to use Flow total and rate display AC or DC Voltage options Analog Output (adjustable) Relay Output Weatherproof Sensors and Casing

Measuring Range Velocity Range 0.3 to 10.0 m/s Accuracy better than ±2% of FS View Volumetric Flow Rate and Total Set Points 0 to 100% of Range Output Active 4-20mA signal 24V DC pulse Programmable Relay Transducer Cable 10ft length (pre-amplifier option allows increased lengths with standard coax cables)		Temperature Steel Sensor -4 to 194 °F Electronics Enclosure IP66 to EN 60529 . Material Al Si 12, DIN 1725. Surface Treatment powder coating Power Input 115/230V ac, 50Hz/60Hz 24V dc +/-10% Transducer IP68 St/Steel 3.1 x 0.9 x 0.8 in with fixed clamping fixtures Indication Display Indication 2 - Line 16 Character Weight Approximately 10lb