Sound travel
in the pipe - Some things we have overcome
EESIFLO have
built in diagnostics for doppler meter applications
but if MINIMUM REQUIREMENTS for doppler measurement
are not met, our meters will reject any readings whether
return signal is insufficient (not enough suspended
solids, gases or simply too low a flow rate to determin
a plausible measurement) The microprocessor based units
will perform continual diagnostic checks on the flow
condition "TESTING SIGNAL" before allowing
a flow measurement to be displayed. The meters do not
allow users to intervene by playing with potentiometers
or adjusting setting. If minimum requirements are no
met our meters will simply not work. This ensures that
there is more chance that the technology is not mis-applied.
Our
instruments and specific system solutions are used for
applications spanning all branches of the process, manufacturing
and municipal sec-tors...
There
were many reasons for this, some people did not have
the service available for rental (so they had to purchase
a unit)...
Measuring
Principle>>
Applications>>
Measurements
are made by penetrating the pipe with ultrasound. Time
differ-ences, frequency variations or phase shifts of
the ultrasonic signals...
You
can practically measure any sonically conductive liquid
without cutting the pipe. It is simply a matter of
minutes to install our meters. Our meters are used
in...
Eesiflo™
Optional Energy Measurement System>>
Eesiflo™
in both fixed and portable versions offers a solution
package using an Energy meter and clamp on sensors we
provide you with the ultimate in Thermal Energy custody
transfer performance.
